
H1Z2Z2-K is the harmonized designation under EN 50618 / IEC 62930 for halogen-free, cross-linked (electron-beam) PV cable. Fine-stranded class 5 tinned copper keeps the conductor flexible and resistant to corrosion, while the double cross-linked polyolefin insulation and sheath withstand UV, ozone, ammonia and continuous conductor temperatures of 90 °C (120 °C for 20,000 h). Rated 1.5 kV DC conductor-to-conductor, it suits every modern 1500 V string inverter.
The 6 mm² cross-section carries roughly 70 A in free air, but in PV the binding constraint is usually voltage drop rather than ampacity. A common design target is ≤1 % DC loss from the farthest module to the inverter or combiner. Voltage drop for a two-wire run is ΔU = 2 × L × I × ρ / A; with copper at about 0.0225 Ω·mm²/m (warm conductor), a 60 m run at 17.5 A on 6 mm² drops about 7.9 V, around 0.8 % of a 1,000 V string. Long home runs on bifacial high-current modules (Imp 17–18 A) are where 6 mm² beats 4 mm².
Installation tips for desert climates: keep cables off sharp tray edges and roof sheets, use UV-stable cable ties (or stainless clips) rather than standard nylon, avoid slack loops that create inductive loops for lightning surges, and route positive and negative conductors of the same string together. Sold per meter, red and black sheaths available, typically on 500 m drums.
0.6/1 kV copper XLPE-insulated, PVC-sheathed (armored on request) cable linking inverters to the AC distribution board, priced as a representative 5-core 10 mm².

Male + female IP68 PV connectors for 4–6 mm² cable, 1500 V DC, certified to IEC 62852.

Parallels two strings onto one MPPT input or cable: one male (+) and one female (−) branch, 1500 V.

Ratchet crimper with 2.5/4/6 mm² dies, insertion tool, unlocking wrenches and cable stripper.

IP65 enclosure with gPV string fuses, Type 2 DC surge protection and a load-break isolator, 1000/1500 V DC.

Rotary load-break DC switch in an IP66 enclosure for safely isolating strings ahead of the inverter.

10×85 mm photovoltaic fuse link (15–32 A) with DIN-rail fuse holder, rated to IEC 60269-6.

Y-configured MOV surge arrester with thermal disconnect and pluggable modules (In 20 kA, Imax 40 kA) for PV strings.

Four-pole C-curve MCB/MCCB (10 kA) protecting each inverter's AC output; representative rating for planning.