
The MC4 plug-and-socket has become the de-facto interface between modules, string cables and inverters. A quality connector uses silver- or tin-plated copper contacts with multilam spring bands, a UV-stable PPO/PA housing and a positive locking latch that needs a tool to release. IEC 62852 sets the test regime: contact resistance (typically ≤0.25 mΩ), temperature cycling, damp heat and ingress protection.
The single most common cause of DC arc faults and fires in PV plants is cross-mating: plugging a connector of one manufacturer into one of another. Even when they look identical, tolerances, contact materials and seals differ, and IEC 62852 certification applies only to mated pairs from the same product family. Always use the same brand and series on both sides of a joint, including where you connect to a module's factory-fitted connector.
Correct assembly matters as much as the part: strip exactly to the specified length, crimp with the matching die (never solder), push the contact in until it clicks, and tighten the cable gland with the proper wrench. A poorly crimped contact heats up under 15–18 A and can burn within months under desert sun.
The cross-section used on module leads and short rooftop string runs; 1500 V DC, halogen-free, UV-resistant.

0.6/1 kV copper XLPE-insulated, PVC-sheathed (armored on request) cable linking inverters to the AC distribution board, priced as a representative 5-core 10 mm².

Parallels two strings onto one MPPT input or cable: one male (+) and one female (−) branch, 1500 V.

Ratchet crimper with 2.5/4/6 mm² dies, insertion tool, unlocking wrenches and cable stripper.

IP65 enclosure with gPV string fuses, Type 2 DC surge protection and a load-break isolator, 1000/1500 V DC.

Rotary load-break DC switch in an IP66 enclosure for safely isolating strings ahead of the inverter.

10×85 mm photovoltaic fuse link (15–32 A) with DIN-rail fuse holder, rated to IEC 60269-6.

Y-configured MOV surge arrester with thermal disconnect and pluggable modules (In 20 kA, Imax 40 kA) for PV strings.

Four-pole C-curve MCB/MCCB (10 kA) protecting each inverter's AC output; representative rating for planning.