
As soon as a site has more than one energy source, something has to decide which one runs when. A site energy management system reads real-time measurements from the PV inverters, battery system, generator controller and grid meter, and dispatches each according to rules or an optimiser: charge the battery from surplus solar, discharge it at peak tariff, shave demand peaks, hold export at zero where the utility requires it, and start the genset only when the battery falls below its reserve.
On off-grid and weak-grid sites in the region, the EMS also protects the generator from low-load running and curtails PV fast enough to prevent reverse power into the genset. For commercial and industrial sites on time-of-use tariffs, most of the value comes from correct tariff logic and a reasonable load forecast.
We supply the EMS controller and configure it: device integration, control strategy, tariff tables, set-points, testing under real operating conditions and a dashboard for the owner. The indicative price is for a typical C&I site with PV, battery and genset.
Work orders, ticketing, preventive maintenance plans and spare-parts stock for teams looking after many PV sites.

Engineering service to configure plant SCADA and the power plant controller, map every signal and prove grid-code performance at commissioning.

Hourly energy simulation with meteo data and detailed loss modelling, producing P50/P90 yields and reports that lenders accept.

Array layout, row spacing, string plans, single-line diagrams and cable routing, from first sketch to construction drawings.

Accurate 3D model of a roof or site from a drone survey, used to quantify shading losses before the design is fixed.

Cloud analysis of BMS data to track state of health, cell imbalance and degradation, and to build evidence for warranty claims.

Physics-based model of the actual plant that runs alongside it, comparing expected and measured output to locate faults and losses.

Connecting plant data to ERP, BI dashboards, billing systems or the utility over Modbus, IEC 104, MQTT and REST.

Network segmentation, hardened remote access and audits against IEC 62443 for plants and fleets connected to the internet.