
An MPPT (maximum power point tracking) controller is a DC-DC buck converter that continuously searches for the voltage at which the array delivers maximum power, then steps it down to battery voltage while raising the current. It recovers the 20–30 % that a PWM controller loses and lets you wire standard grid modules in series at higher voltage, reducing cable size and losses. Peak conversion efficiency is around 98 %.
Sizing: maximum charge current × battery voltage gives the usable PV power — 60 A covers about 800 W at 12 V, 1.6 kW at 24 V and 3.2 kW at 48 V; arrays can be oversized by 10–30 % since the controller simply limits current. The critical limit is the 150 V maximum PV voltage: calculate string Voc at the coldest expected temperature (Voc × [1 + |tempCoeffVoc| × (25 − Tmin)]) and keep it below 150 V. In the Gulf, winter mornings near 10 °C still push Voc about 4 % above STC; three 72-cell modules (Voc ≈ 50 V each) would be too many, two is correct.
The controller offers configurable absorption/float voltages, temperature compensation via a remote sensor for lead-acid, and BMS communication with compatible lithium batteries. Mount it vertically with 15 cm clearance for convection cooling — heat sinks derate above 40 °C ambient — and install a DC breaker on the PV side and a fuse on the battery side.
Wheeled LFP power unit with 3.6 kW inverter, dual MPPT inputs and add-on battery packs up to about 20 kWh: home backup with no installer needed.

ETFE-laminated monocrystalline panel that folds into a briefcase with kickstands. Connects to power stations through an MC4 or XT60 adaptor.

Complete small system for cabins, kiosks, campers and farm huts: 2 × 200 W panels, 30 A MPPT, 12.8 V 100 Ah LFP battery, 1 kW pure-sine inverter, cables and fuses.

Cabin, farm or remote-site package: 1.5 kWp of modules, an all-in-one 3 kW inverter with built-in MPPT and charger, 25.6 V 200 Ah LFP, mounting and wiring.

Low-cost controller for small 12/24 V systems with panels matched to battery voltage; LCD, USB outputs and selectable lead-acid or lithium profiles.

Heavy-duty controller for 48 V battery banks up to 5.8 kW of PV, with longer strings, parallel operation and network monitoring for farms, telecom and remote sites.

Charges a vehicle or boat house battery from the alternator and roof panels at the same time, with the correct lithium profile and starter-battery protection.

Transformer-based inverter with 3× surge capacity for motors, pumps and compressors, a built-in battery charger and automatic transfer from grid or generator.

Panel, LFP battery, controller, LED head and motion sensor in one housing for 6–8 m poles. Lights roads, compounds and car parks with no trenching or grid connection.