
Modern vehicles use smart (variable-voltage) alternators that may drop to 12.5 V while driving, which never fully charges a second battery through a simple relay or isolator. A DC-DC charger boosts and regulates that input to a proper multi-stage charge — 14.4 V absorption for LFP or AGM — and limits current to protect both the alternator and the wiring. The integrated MPPT input accepts up to around 400–500 W of roof or foldable panels (Voc up to 50 V) and blends both sources, prioritising solar when the engine is off.
The 50 A rating suits house batteries from 100 Ah to 300 Ah. Wire it with short, heavy cables — typically 25 mm² for runs up to 5 m at 50 A — with a fuse at each battery. The charger senses ignition (or a D+ signal) so that it only draws from the starter battery while the engine runs, and it cuts out below a set voltage to guarantee the engine still starts.
Typical uses are camper vans, overland 4×4s, ambulances, work utes with fridges and inverters, and small boats. In hot climates, mount it away from the engine bay; most units derate above 40–50 °C and LFP batteries must not be charged above about 55 °C cell temperature.
Wheeled LFP power unit with 3.6 kW inverter, dual MPPT inputs and add-on battery packs up to about 20 kWh: home backup with no installer needed.

ETFE-laminated monocrystalline panel that folds into a briefcase with kickstands. Connects to power stations through an MC4 or XT60 adaptor.

Complete small system for cabins, kiosks, campers and farm huts: 2 × 200 W panels, 30 A MPPT, 12.8 V 100 Ah LFP battery, 1 kW pure-sine inverter, cables and fuses.

Cabin, farm or remote-site package: 1.5 kWp of modules, an all-in-one 3 kW inverter with built-in MPPT and charger, 25.6 V 200 Ah LFP, mounting and wiring.

Low-cost controller for small 12/24 V systems with panels matched to battery voltage; LCD, USB outputs and selectable lead-acid or lithium profiles.

Tracks the panel's maximum power point and converts excess voltage into charging current. Handles up to 3.2 kW of PV at 48 V, with Bluetooth monitoring and lithium profiles.

Heavy-duty controller for 48 V battery banks up to 5.8 kW of PV, with longer strings, parallel operation and network monitoring for farms, telecom and remote sites.

Transformer-based inverter with 3× surge capacity for motors, pumps and compressors, a built-in battery charger and automatic transfer from grid or generator.

Panel, LFP battery, controller, LED head and motion sensor in one housing for 6–8 m poles. Lights roads, compounds and car parks with no trenching or grid connection.