
Portable panels trade the glass and aluminium frame of a rooftop module for a lightweight ETFE-laminated cell sheet sewn into a fabric case. A 200 W unit typically uses high-efficiency monocrystalline (PERC, TOPCon or back-contact) cells at 22–24 % cell efficiency, weighs 7–9 kg and folds to about 60 × 55 cm. Open-circuit voltage is around 22–24 V (12 V class), so two can be wired in series for power stations that accept 40–60 V input, halving cable current.
Real output is lower than the label: expect 130–160 W at noon on a hot day because cell temperature reaches 60–70 °C on a dark fabric back, and the panel loses roughly 0.35 %/°C. Angle it toward the sun every hour or two and keep it on its stands rather than flat on sand. Avoid partial shading by a shadow across a single fold — it can halve output because the cells in a fold form one string.
The panel is splash-resistant (often IP65–IP67 on the junction box), but the fabric and connectors are not designed for permanent outdoor mounting. For fixed installations on cabins or boats, a rigid framed module is cheaper per watt and lasts far longer.
Wheeled LFP power unit with 3.6 kW inverter, dual MPPT inputs and add-on battery packs up to about 20 kWh: home backup with no installer needed.

Complete small system for cabins, kiosks, campers and farm huts: 2 × 200 W panels, 30 A MPPT, 12.8 V 100 Ah LFP battery, 1 kW pure-sine inverter, cables and fuses.

Cabin, farm or remote-site package: 1.5 kWp of modules, an all-in-one 3 kW inverter with built-in MPPT and charger, 25.6 V 200 Ah LFP, mounting and wiring.

Low-cost controller for small 12/24 V systems with panels matched to battery voltage; LCD, USB outputs and selectable lead-acid or lithium profiles.

Tracks the panel's maximum power point and converts excess voltage into charging current. Handles up to 3.2 kW of PV at 48 V, with Bluetooth monitoring and lithium profiles.

Heavy-duty controller for 48 V battery banks up to 5.8 kW of PV, with longer strings, parallel operation and network monitoring for farms, telecom and remote sites.

Charges a vehicle or boat house battery from the alternator and roof panels at the same time, with the correct lithium profile and starter-battery protection.

Transformer-based inverter with 3× surge capacity for motors, pumps and compressors, a built-in battery charger and automatic transfer from grid or generator.

Panel, LFP battery, controller, LED head and motion sensor in one housing for 6–8 m poles. Lights roads, compounds and car parks with no trenching or grid connection.