
For homes, villas, carports and smaller commercial roofs, a water-fed pole is the safest and most economical way to clean modules. The operator stays on the ground or on a walkway instead of walking on the array, and the pole extends to about 7–10 m. Water runs through the pole to jets in the brush head, loosening dust while the soft bristles lift it without scratching the anti-reflective coating. With purified water the glass dries without spots, so no squeegee or rinse is needed.
The set includes the telescopic pole, a hose reel, brush heads and connectors for a mains tap or a pure-water unit. Clean early in the morning or late afternoon: cold water on glass at 70 °C can stress it, and the coolest hours also avoid evaporation marks. Never use detergents, abrasive pads or high-pressure jets unless the module manufacturer approves them, and check that the module warranty conditions are met. In dusty Gulf locations a monthly wash, plus a wash after sandstorms, is a typical starting point.
Battery-powered rotating brush on a telescopic pole for rooftops and small plants; optional water connection.

Field instrument that measures the full current-voltage curve of a string and compares it with the datasheet at STC.

Aerial infrared survey that detects hot spots, failed diodes, disconnected strings and cracked modules across an entire plant in hours.

CAT III 1500 V kit: insulation resistance, Voc, Isc, polarity, earth continuity and DC clamp current for commissioning and fault-finding.

Arc-rated clothing, face shield, insulated gloves and safety footwear for work on live PV DC and LV AC equipment.

Optional nano-coating applied on site that reduces dust adhesion and makes cleaning easier; lasts 1–3 years.

Pair of glass-fibre reinforced spanners for tightening MC4 cable glands and releasing the locking latches without damaging the housing.

Pocket meter reading plane-of-array irradiance in W/m² and module back-sheet temperature — the quick reference for commissioning and performance checks.

Radiometric infrared camera for finding hot cells, failed bypass diodes, loose terminals and overheated fuses in modules, combiner boxes and switchboards.