
The clamp meter is the everyday fault-finding tool of a PV technician. Its Hall-effect jaw reads DC current up to 1000 A, so each string in a combiner box can be clamped in turn and compared: in a healthy array strings of the same length and orientation carry currents within a few percent of each other, and one string reading low points to a blown fuse, a disconnected connector, soiling or shading. The 1500 V DC voltage range covers open-circuit voltage of modern utility strings, and AC functions measure inverter output and neutral current on the AC side.
Choose a meter certified to IEC 61010 CAT III 1500 V DC — ordinary meters rated 1000 V are not safe on 1500 V systems. Zero the DC current reading before each measurement, keep the conductor centred in the jaw, and test leads must carry the same rating. It does not replace an IV-curve tracer or an insulation tester, but it answers most first-line questions in minutes.
Battery-powered rotating brush on a telescopic pole for rooftops and small plants; optional water connection.

Field instrument that measures the full current-voltage curve of a string and compares it with the datasheet at STC.

Aerial infrared survey that detects hot spots, failed diodes, disconnected strings and cracked modules across an entire plant in hours.

CAT III 1500 V kit: insulation resistance, Voc, Isc, polarity, earth continuity and DC clamp current for commissioning and fault-finding.

Arc-rated clothing, face shield, insulated gloves and safety footwear for work on live PV DC and LV AC equipment.

Optional nano-coating applied on site that reduces dust adhesion and makes cleaning easier; lasts 1–3 years.

Pair of glass-fibre reinforced spanners for tightening MC4 cable glands and releasing the locking latches without damaging the housing.

Pocket meter reading plane-of-array irradiance in W/m² and module back-sheet temperature — the quick reference for commissioning and performance checks.

Radiometric infrared camera for finding hot cells, failed bypass diodes, loose terminals and overheated fuses in modules, combiner boxes and switchboards.