
A 16-series LFP pack has a nominal 51.2 V and works between roughly 40 V and 58.4 V. The BMS measures every cell voltage, several NTC temperatures and the pack current, and opens its MOSFET switch on cell over- or under-voltage, over-current, short circuit and charging below 0 °C or above about 55 °C. It estimates state of charge by coulomb counting and reports it, along with charge-voltage and current limits, to the inverter over CAN or RS485 using the common hybrid-inverter protocols.
Passive balancing bleeds roughly 50–150 mA from the highest cells near full charge. That is adequate for well-matched, graded cells; for large-capacity cells or mixed batches, pair it with an active balancer. Choose the continuous-current rating from the inverter's maximum battery current plus margin: 100 A suits up to about 5 kW, 200 A up to about 10 kW. Check that the protocol list includes the inverter you will use, and keep sense wires short and fused at the cell end.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.

Schottky bypass diodes for PV junction boxes that route current around shaded or damaged cell groups and prevent hot spots.