
The control board is the inverter's brain. A DSP or high-end MCU samples DC and AC voltages and currents through precision ADC channels, runs the MPPT algorithm for each tracker, locks to the grid with a PLL and generates the PWM pattern sent to the power stage. The same board supervises insulation resistance, residual current, anti-islanding and over-temperature, and hosts the RS485, CAN, Wi-Fi or Ethernet interfaces used by the display, BMS and monitoring.
When an inverter shows persistent sampling faults, communication loss with the power board or a frozen display while the power stage tests healthy, the control board is the usual suspect. A replacement must match the hardware revision of the original and be loaded with the correct firmware and country grid code; boards are therefore supplied against the inverter model, rating and serial-number range. After fitting, the installer should re-run the self-test, confirm grid parameters and check that the serial number is re-registered on the monitoring portal.
Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.

Schottky bypass diodes for PV junction boxes that route current around shaded or damaged cell groups and prevent hot spots.