
Every grid-connected inverter must be able to disconnect from the grid on a fault or loss of mains, and most do this with PCB power relays on the AC output, two in series per line so that a single welded contact cannot leave the output live. The control board checks each relay at start-up; a relay self-test failure is one of the most common error codes on residential inverters after several years in hot climates.
These relays are rated 40 A at 250/277 V AC with a contact gap of at least 1.5 mm, as required by several grid codes, and use silver-tin-oxide contacts that resist welding under inrush. Many types offer a reduced holding voltage to cut coil power and heat. When replacing, match the coil voltage (typically 12 V DC), the pin layout and the contact gap, and replace all relays in the output path together. Solder joints on these high-current pins should be inspected, since cracked joints cause similar symptoms to a faulty relay.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

Schottky bypass diodes for PV junction boxes that route current around shaded or damaged cell groups and prevent hot spots.