
This board is a complete synchronous buck converter with an MCU running perturb-and-observe MPPT. It accepts PV input up to about 150 V open-circuit, steps it down to the battery voltage and regulates charging in bulk, absorption and float stages. Lead-acid, gel and lithium (LFP) profiles are selectable, and the 12, 24 or 48 V system voltage is detected at power-up. Peak conversion efficiency is around 98 % at mid load.
Integrators use it to build controllers into custom enclosures, solar street-light cabinets and telecom shelters, or to repair controllers whose original board has failed. The heavy copper tracks and MOSFETs need a heat sink and some airflow; above 45 °C ambient the board derates current automatically. Protection includes PV reverse polarity, battery reverse polarity (via fuse), over-temperature and output short circuit. An RS485 header allows remote reading of PV power and battery state.
Always connect the battery first, then the PV array, and size the PV string so its cold-morning Voc stays below the input limit.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.

Schottky bypass diodes for PV junction boxes that route current around shaded or damaged cell groups and prevent hot spots.