
The DC-link capacitor sits between the boost stage and the inverter bridge, absorbing the high-frequency ripple current drawn by the switching transistors and holding the bus voltage steady. Modern inverters increasingly use metallised polypropylene film rather than electrolytic capacitors here: film tolerates higher ripple per microfarad, has very low ESR and inductance, does not dry out, and clears small dielectric faults by self-healing instead of failing short.
Typical PCB-mount types range from 20 to 200 µF at 800–1200 V DC, rated for 85 °C or 105 °C operation and 100,000 hours at rated voltage and moderate hot-spot temperature. When selecting a replacement, match capacitance, rated voltage, ripple-current rating and pin pitch; a lower ripple rating will overheat even if voltage and capacitance are correct. Capacitors that show bulging, cracked resin or a capacitance drop of more than about 5 % from nominal should be replaced as a set.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.

Schottky bypass diodes for PV junction boxes that route current around shaded or damaged cell groups and prevent hot spots.