
A lithium battery should never be run by voltage settings alone. Over CAN, the BMS sends the inverter its live charge-voltage limit, charge and discharge current limits, state of charge, alarms and a request to stop charging, typically every second. The inverter then follows the battery's own limits instead of fixed set-points, which protects the cells and lets the system use the full usable capacity.
Problems arise when the battery and inverter do not share a protocol, or when the BMS only speaks RS485 while the inverter expects CAN. This module bridges the two: an isolated CAN transceiver (125–500 kbit/s) with a microcontroller that translates between common battery and inverter protocols, configurable over USB. It is also used to aggregate several battery packs into one CAN message stream for the inverter.
Use twisted-pair cable with 120 Ω termination at both ends of the bus, check the RJ45 pin-out on both devices, since CAN-H and CAN-L positions differ between makes, and confirm protocol selection on the inverter before commissioning.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.