
Many sites need a small, reliable 12 V or 24 V supply alongside a 48 V battery: monitoring routers, data loggers, contactor coils, tracker controllers or DC lighting. Tapping four cells of the battery for 12 V unbalances the pack; a DC-DC converter avoids that and regulates the output regardless of battery state of charge. Input range is typically 36–75 V, covering a 16S LFP pack from empty to fully charged, with output adjustable by a few percent.
Isolation (usually 1500 V DC or more between input and output) separates the auxiliary circuit from the battery, so ground loops and fault currents cannot travel between them, and the 12 V side can be earthed independently. Modules range from 50 W to 500 W at around 90–94 % efficiency, with input under-voltage lock-out, output short-circuit and over-temperature protection. Mount them on a metal plate or DIN-rail heat sink, fuse the input close to the battery, and derate above about 50 °C ambient.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.