
A shunt is a precisely calibrated low-value resistor placed in series with the battery negative. At 500 A it develops 75 mV, so its resistance is 0.15 mΩ; a battery monitor or BMS measures that small voltage to calculate current and, by integrating it, state of charge. Manganin is used for the resistive element because its resistance barely changes with temperature, which keeps readings stable as the shunt warms under load.
Shunts are rated for continuous operation at around two-thirds of nominal current, so a 500 A shunt suits systems with up to about 330 A continuous. Use the large bolts for the main current and the small screws for the sense leads only, and keep the sense leads twisted and short to avoid picking up inverter noise. Mount the shunt on a non-combustible surface with clearance for air, since it dissipates about 37 W at full current. Install it so that all loads and chargers, including the inverter, return through the shunt; anything bypassing it makes the state-of-charge figure drift.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.