
Board-level fuses protect auxiliary power supplies, fan outputs, communication ports and BMS sense lines. They are a different product from the gPV string fuses used on the DC array side: small, low-energy and usually soldered or clipped onto the PCB. A blown auxiliary fuse is a frequent cause of an inverter that shows no display at all, and replacing it, after finding why it blew, is often the whole repair.
The box contains the values that repair technicians use most: 5×20 mm and 6×30 mm glass and ceramic cartridge fuses from 0.5 to 10 A in fast-acting and time-lag versions, radial TR5 micro fuses, SMD 1206 and 1812 chip fuses, and polymer PTC resettable fuses from 0.1 to 3 A. PTCs suit circuits where a short is likely to be temporary, such as RS485 and sensor ports, and reset once the fault is removed and they cool.
Always replace like with like: the same current rating, breaking capacity, voltage rating and characteristic. A ceramic high-breaking fuse should never be replaced by a glass one, and never bridge a fuse during testing.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.