
A power module is only as reliable as its gate drive. The driver board takes logic-level PWM from the controller and turns it into the gate voltages the module needs, typically +15/−8 V for IGBTs or +18/−4 V for SiC, across an isolation barrier rated for the DC bus voltage. Each channel has its own isolated DC-DC supply and peak output currents of several amperes to charge the gate quickly and limit switching losses.
Protection is the other half of its job. Desaturation (VCE monitoring) detects a short circuit within a few microseconds; the driver then switches off softly to avoid destructive overvoltage from stray inductance, and reports the fault back to the controller. Under-voltage lock-out on both sides prevents the module from being driven with insufficient gate voltage, and an active Miller clamp stops parasitic turn-on in half-bridge configurations.
Boards are available for 62 mm and common module outlines in 1200 V and 1700 V classes. Gate resistors are fitted to suit the module; when changing module type, recalculate them and confirm switching behaviour with a double-pulse test.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.