
A closed-loop (compensated) Hall sensor places a Hall element in the air gap of a magnetic core around the primary conductor. An amplifier drives a secondary winding to cancel the core flux; the secondary current is then an exact scaled copy of the primary current. Because the core always operates near zero flux, linearity and temperature drift are far better than open-loop types, typically within ±0.5 % overall, with response times under 1 µs and bandwidth up to 200 kHz.
That combination of DC capability, galvanic isolation and speed is why closed-loop sensors are used for output-current control and over-current protection in inverters and PCS, and for accurate coulomb counting in large battery systems. Through-hole PCB versions cover roughly 25–300 A; panel types with a primary aperture cover up to 2000 A. Supply is ±15 V or a single 5 V with a 2.5 V reference output. Mount the sensor with the conductor centred in the aperture and the arrow in the direction of positive current.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.