
Every watt lost in a semiconductor must leave through the heat sink. The required thermal resistance follows directly from the losses and the allowed temperature rise: a module dissipating 200 W with a 125 °C junction limit at 50 °C ambient needs a total junction-to-air resistance below about 0.37 K/W, from which the junction-to-case and interface resistances are subtracted to find the heat-sink figure. Profiles are selected from their published thermal resistance per length under natural convection or forced airflow.
We supply standard comb and bonded-fin profiles in 6063-T5 alloy, cut to length with a flat, machined mounting face (flatness better than about 0.05 mm over the module footprint), drilled and tapped to the module pattern, and anodised black or clear. Forced-air versions with fan mounting are available for inverters and chargers.
Thermal results depend on assembly as much as on the profile: apply a thin, even layer of thermal grease or a phase-change pad, torque screws in the sequence given by the module maker, and orient fins vertically for natural convection.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.