
IP65 means the enclosure is dust-tight and protected against water jets from any direction, which covers rain, washing and the fine sand typical of the region. It does not, by itself, solve heat: a closed box in direct sun can reach 70 °C inside. Choose the material for the site. UV-stabilised polycarbonate is light, non-conductive and stays transparent if a window is needed. ABS is cheaper but should stay out of direct sun. Powder-coated steel or stainless steel suits larger assemblies, mechanical protection and metal grounding.
Enclosures are supplied with a removable mounting plate, captive lid screws or lockable latches, and a continuous PU gasket. Sizes range from small boxes around 200 × 150 × 100 mm for a dongle or RS485 converter up to 600 × 400 × 200 mm cabinets for routers, loggers and DIN-rail power supplies.
To keep the IP rating, use correctly sized cable glands, mount glands on the bottom face, and fit a breather vent to prevent condensation. In hot locations, install the box on the shaded side of the structure or under a sun shield.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.