
Lithium cells must not be charged below 0 °C or operated much above 55–60 °C, so the BMS needs reliable temperature readings from inside the pack. The standard method is a 10 kΩ NTC thermistor (B25/50 = 3435 K or 3950 K) bonded to a cell or clamped under a busbar bolt. Its resistance falls as temperature rises, and the BMS converts the reading through the matching resistance–temperature table.
The ring-lug format suits bolted cell terminals: the sensor sits under the busbar nut and measures the terminal temperature, which tracks the cell's internal temperature closely and also shows a loose or high-resistance connection early. Leads are PTFE- or silicone-insulated, 300–1000 mm long, with the connector to order. Accuracy is ±1 % at 25 °C.
Before ordering, check the B-value and resistance your BMS expects; a 3950 K sensor read by a BMS calibrated for 3435 K will show errors of several degrees at the temperature extremes. Place sensors at the centre of the pack and near the main terminals, where temperatures run highest.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.