
RS485 with Modbus RTU remains the backbone of PV site communication: inverters, meters, weather stations and combiner-box monitors are daisy-chained on one twisted pair to the logger. On large sites the devices sit hundreds of metres apart, at different earth potentials and near high-current DC cabling. Non-isolated interfaces then suffer communication dropouts or are destroyed by surges. An isolated module separates the bus from the device electronics with a 2.5–5 kV barrier and adds TVS surge protection on the A/B lines.
Versions are available as a PCB module for integration, a DIN-rail RS485 repeater/isolator to split a long bus into segments, and USB-to-RS485 or RS485-to-Ethernet converters for commissioning and logger connection. Good practice: use shielded twisted pair, earth the shield at one end only, terminate both ends of the bus with 120 Ω, keep to a daisy-chain without long stubs, and limit each segment to 32 unit loads and about 1200 m at 9600 baud.
Power-stage board carrying the boost and inverter bridges, gate drivers and DC-link capacitors. The major spare most often needed after surge or overheating damage.

Assembled MPPT buck-converter board with automatic 12/24/48 V battery detection, for off-grid controller builds and repairs.

Battery management board for 48 V-class LFP packs with cell monitoring, MOSFET switching, passive balancing and CAN/RS485 inverter communication.

Capacitive or inductive energy-transfer balancer that moves charge between cells continuously, keeping large LFP packs aligned.

Industry-standard 62 mm half-bridge IGBT module with anti-parallel diodes, used in central and large string inverters, PCS and motor drives.

Silicon-carbide half-bridge module for high-frequency, high-efficiency inverters, DC/DC stages and fast chargers.

Self-healing metallised-polypropylene capacitor for inverter DC buses, with high ripple-current rating and long life at elevated temperature.

Sealed, gas-filled DC contactor for battery racks, PCS and high-voltage battery packs, with magnetic arc blow-out and auxiliary contact.

PCB-mount power relay used as the AC output disconnect in string and hybrid inverters, with wide contact gap for grid-code isolation.