
The frame stiffens the laminate, transfers wind and snow loads to the mounting structure and protects the glass edge. Each set includes two long-side and two short-side profiles plus four corner keys, with mounting, drainage and grounding holes punched to your drawing. Most modules today use 30 or 35 mm high profiles; 6005-T6 offers higher strength for large-format and high-load ratings, while 6063-T5 is the economical choice for standard sizes.
Anodising of at least 15 µm (often specified as AA15 or higher) protects against corrosion; for coastal or desert sites, ask for 15–20 µm and salt-mist test reports. Check wall thickness, flatness and twist, corner-key fit and the cavity size for the sealant or tape that bonds the frame to the laminate. Coated steel frames are emerging as a lower-cost alternative, but aluminium remains the default for weight and corrosion resistance. Price is per set and depends on profile weight and aluminium price.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.