
Metallisation paste is the largest non-silicon cost in a cell. TOPCon uses a silver-aluminium paste on the boron-doped front and a fine-line silver paste on the rear polysilicon, both fired at high temperature; HJT needs low-temperature curing pastes because its amorphous layers cannot be fired. Typical consumption is around 8–10 mg/W for TOPCon and higher for HJT unless silver-coated copper is used.
With silver prices at multi-year highs, cell makers are cutting silver hard: finer printed fingers, 0BB designs that remove busbars, silver-coated copper pastes with 30–50 % silver in HJT, and early copper plating and copper paste trials for TOPCon and BC. Any change of paste needs line qualification, because contact resistance, firing profile and reliability shift with each formulation.
Pricing is indexed: quotes are built from the silver spot price on the order date plus a processing fee per kilogram, so no fixed price is listed. Pastes are shipped in sealed jars with temperature control and have a limited shelf life; store them cool and roll them before use.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Low-iron patterned front glass, fully tempered with anti-reflective coating and about 94 % transmittance, for glass-backsheet modules.