
Monocrystalline ingots for solar cells are grown by the Czochralski method: polysilicon is melted in a quartz crucible, a seed crystal is dipped in and slowly withdrawn while rotating, and a single crystal grows from the melt. Modern pullers use recharged Cz (RCz), topping up the crucible between pulls so that several ingots come from one crucible, which lowers cost per kilogram. Phosphorus is added as the dopant to make N-type material, which is immune to the boron-oxygen light-induced degradation of older P-type wafers.
Because phosphorus segregates along the crystal, resistivity drifts from the seed end to the tail; typical targets are about 0.5–1.5 Ω·cm for TOPCon and somewhat higher for heterojunction. Other key values are interstitial oxygen, minority-carrier lifetime (usually well above 1 ms after passivation) and freedom from dislocations. Ingots are supplied cropped and squared to the wafer format, with a test sheet for each piece.
Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.

Low-iron patterned front glass, fully tempered with anti-reflective coating and about 94 % transmittance, for glass-backsheet modules.