
A backsheet insulates the circuit electrically, keeps moisture out and protects the module's rear from UV and abrasion. The usual build is a thick PET core of about 250 µm for dielectric strength, a weather-resistant fluorinated outer layer (film or coating), and an inner layer chosen for adhesion to the encapsulant. Common structures are described as KPf, KPK, CPC or similar, depending on whether the outer and inner layers are fluoropolymer films or coatings.
Points to check are partial-discharge voltage for 1500 V systems, water-vapour transmission rate, peel strength to EVA or POE, and reflectance of the white inner surface, which returns light to the cells and lifts power slightly. In the Gulf, the outer layer's UV and sand-abrasion resistance matters, as early field failures of cheaper backsheets show up as cracking and chalking. Total thickness is usually around 0.30 mm; supplied in rolls cut to module width.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.