
EVA has been the standard encapsulant for decades: it laminates quickly, bonds well to glass and cells, and is the cheapest option per square metre. Solar grades contain roughly 28–33 % vinyl acetate with a peroxide curing agent, UV stabilisers and adhesion promoters. During lamination the film melts, flows around cells and ribbons, and cross-links; a gel content of about 75–90 % after curing is the usual acceptance window.
UV-cut grades block short-wavelength light to protect the cells and backsheet, while UV-transparent grades let more light through for a small power gain on the front side. EVA's weakness is that it can release acetic acid when moisture gets in, which corrodes metallisation and worsens PID; this matters most for N-type cells. For TOPCon and HJT, use EVA only where the design allows, or switch to EPE or POE. Store rolls sealed, cool and dry, and use within the stated shelf life.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.