
Room-temperature-vulcanising (RTV) silicone cures by reacting with moisture in the air. Solar grades are neutral-cure (alkoxy or oxime), so they release no acetic acid that could corrode metal or attack the encapsulant. In the framing step the sealant is dispensed into the frame groove before the laminate is pressed in, filling the gap and keeping water away from the glass edge; the same or a similar grade fixes the junction box base.
Useful properties to compare are skin-over time (typically 10–30 minutes), depth of cure (around 3 mm per 24 hours), tensile and shear strength, elongation, and adhesion to anodised aluminium, glass, backsheet and box plastics. Modules should rest in a controlled curing area before the frame is loaded. Some lines use double-sided foam tape in the frame instead; silicone remains the more forgiving choice for frame tolerances. Supplied in drums or pails for pump dispensing, or cartridges for rework.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.