
The rear pane of a bifacial dual-glass module does two jobs: it lets reflected light reach the back of the cells, and it closes the laminate against moisture far better than a polymer backsheet. A white ceramic glaze screen-printed in the gaps between cells and around the edge reflects light that would otherwise pass straight through, returning it to the cells and typically adding around 1–1.5 % to front-side power. The glaze is fired in during heat-strengthening, so it does not peel or fade.
Holes for the ribbon outlets are drilled before strengthening to match your junction box layout, usually three holes for a split box. Give the supplier a drawing with hole positions, diameters and grid pattern matched to your cell size and spacing; any mismatch will show as shading on the rear. As with front glass, flatness and edge quality govern lamination yield.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.