
POE is a non-polar polymer, so it absorbs and passes far less moisture than EVA and contains no acetate groups that could turn into acid. Its volume resistivity is also higher, which limits the leakage currents behind potential-induced degradation. These properties make it the preferred rear encapsulant for dual-glass bifacial modules and a safe choice on both sides for moisture-sensitive TOPCon and HJT cells.
The trade-offs are cost and processing. POE needs a longer lamination cycle, can be slippery during layup so strings shift, and its additives can bloom to the surface if storage is poor. Some grades carry more peroxide and wear laminator membranes faster. Run trials to set lamination time and temperature, check gel content and peel strength to glass, and keep rolls sealed until use. Thickness is typically 0.45–0.60 mm depending on cell thickness and ribbon diameter.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.