After the ribbons are soldered to the junction box terminals, the box is filled with a two-part silicone that cures into a soft, elastic solid. The potting compound keeps out moisture and dust, insulates live parts, damps vibration and conducts heat from the bypass diodes to the box walls. Most products mix at 1:1 or 10:1 by weight or volume, with addition or condensation curing.
Key specifications are mixed viscosity (low enough to flow around terminals without voids), pot life and cure time at line temperature, thermal conductivity of roughly 0.4–0.8 W/m·K, dielectric strength, UL 94 V-0 flame rating, and adhesion to the box plastic. Addition-cure grades can be inhibited by sulphur, amines or some solder fluxes, so test them with your actual components. Use automatic meter-mix dispensers and check for bubbles and incomplete filling during first-article inspection.
Phosphorus-doped Czochralski ingot, cropped and squared for M10, G12R or G12 wafering, with resistivity and lifetime data per piece.

Diamond-wire-cut N-type monocrystalline wafer, about 130 µm thick, in the near-square M10 format used for TOPCon and HJT cells.

Rectangular 210R wafer for the 2382 × 1134 mm module format: more power per module while staying within standard container and handling limits.

Full-size 210 mm square N-type wafer for high-power utility modules above 700 W, usually cut into half or third cells.

Gallium-doped P-type PERC cell, about 23.3–23.6 % efficient, for cost-driven modules and replacement production on existing lines.

Mainstream N-type cell in M10 or G12R format, around 26 % efficient with 80–85 % bifaciality, for glass-glass and glass-backsheet modules.

Low-temperature N-type cell with amorphous-silicon passivation, high bifaciality and the best temperature coefficient among mainstream technologies.

Cell with all contacts on the rear and an unshaded front, the highest-efficiency mass-produced option at 26.5–27 %+, suited to premium rooftop modules.

Screen-printing pastes for TOPCon, PERC and HJT cells, including silver-aluminium, fine-line silver, low-temperature and silver-coated copper grades; price indexed to silver.